Aries Electronics - Your Best Source for Interconnection and Packaging Solutions
Series 675 DIP Program Header
CUSTOMIZATION: IN ADDITION TO THE STANDARD PRODUCTS SHOWN ON THIS PAGE, ARIES SPECIALIZES IN CUSTOM DESIGN AND PRODUCTION. SPECIAL MATERIALS, PLATINGS, SIZES, AND CONFIGURATIONS CAN BE FURNISHED, DEPENDING ON QUANTITY. NOTE: ARIES RESERVES THE RIGHT TO CHANGE PRODUCT SPECIFICATIONS WITHOUT NOTICE.

Series 675 DIP Program Headers

FEATURES

  • Aries DIP programmable headers offer unusual versatility for programming within the header itself.
  • They can be individually programmed using cutters or Aries programming tool, P/N T-675, available separately, to remove the interconnecting sections. Consult Data Sheet 22002 for Aries programming tool.
  • Adjacent and/or opposing pins are interconnected until the pre-slotted section is programmed out. An almost infinite number of programs can be attained by merely leaving or removing interconnecting sections.
  • A low profile, snap-on cover protects header from dirt or accidental damage, and can be marked to identify the program within the header.

GENERAL SPECIFICATIONS

  • STANDARD HEADER BODY AND COVER: black UL 94V-0 4/6 Nylon
  • PINS: Brass 260 3/4-hard, ASTM B-36
  • PIN PLATING: “-T” 200μ [5.08μ] min. matte Sn per ASTM B545-97 2004e1 over 50μ [1.27μ] min. Ni per QQ-N-290; “-G” 10μ [0.25μ] Au per MIL-G-45204 over 50μ [1.27μ] min. Ni per QQ-N-290; “-TL” 200μ [5.08μ] 90/10 Sn/Pb per MIL-T-10727 Type I over 50μ [1.27μ] min. Ni per QQN-290
  • CURRENT RATING: 2 amps
  • OPERATING TEMPERATURE: 221°F [105°C] Sn or Sn/Pb plating; 257°F [125°C] Au plating

MOUNTING CONSIDERATIONS

  • SUGGESTED PCB HOLE SIZE: 0.035 ±0.002 [0.89 ±0.05] dia.
NOTICE   ORDERING INFORMATION

ALL DIMENSIONS: INCHES [MILLIMETERS]

ALL TOLERANCES: ±0.005 [0.13] UNLESS OTHERWISE SPECIFIED

“A” = (NO. OF PINS PER ROW x 0.100 [2.54]) + 0.050 [1.27]
“B” = (NO. OF PINS PER ROW -1) x 0.100 [2.54]

COVERS AVAILABLE FOR 8-, 14- AND 16-PIN HEADERS. TO ORDER, SPECIFY P/N XX-650-10, WHERE “XX” DENOTES THE NUMBER OF PINS. CONSULT DATA SHEET 12033 FOR ADDITIONAL INFORMATION.

CONSULT FACTORY FOR OTHER SIZES AND CONFIGURATIONS

PRINTOUTS OF THIS DOCUMENT MAY BE OUT-OF-DATE AND SHOULD BE CONSIDERED UNCONTROLLED

  

 
Reference-Only Drawing for Series 675 DIP Program Header

 

Download Data Sheet 16004, Rev AA